Blueprint Heating Designs
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
Blueprint Retrofit System
![]() |
|
Above: 4-PHFCL-DIR 4 PUMP HEATING FLAT CAGE LIMITED 1 zone of radiant floor heating by injection mixing strategy plus domestic hot water generation |
Blueprint flat cages are used in new construction, or to correct faulty existing mechanical rooms. In some cases tenants may suffer from a past incorrect design/installation. The owner should consider salvaging any good aspects of the existing design and then retrofit the correct Blueprint flat cage solution.
The featuring "flat cage" displayed o this page, provides:
- One high-temperature-hot-water heating zone for potable-hot-water production via an indirect fired storage vessel.
- And one low temperature zone of radiant floor heating.
Note:
The cage deplicted is limited because the low water cut-off, expansion tank,
pressure reducing fill valve, backflow preventer and high limit control are not inluded.
In most retrofit cases these componets were available and savagable.
In new construction appications these items can be externally installed seperatly by others.
Produced and designed by Photoenhancements.com
© 2003-11
No reproduction of materials without written permission of Photoenhancements.com









